Publicité
Les langues disponibles
Les langues disponibles
4 OPERATING YOUR O2+ SOURCE AIR PURIFIER
4.1 TURN THE O2+ SOURCE ON/OFF
1.
To turn on the O2+ Source, first plug it into an electric outlet. The control panel lights will
flash twice and you will hear a beep.
2.
Press the Power Button to switch the appliance ON. The control panel lights and Air
Quality Indicator light will power on, and you will hear a beep. Once powered on, the
Source will be in AUTO mode with the fan speed setting at 2 and air quality indicator
colored green for the first 2 minutes, then it will adjust automatically.
3.
To turn OFF, press and hold the Power Button for about 5 seconds, the appliance will beep
and the lights will power off.
4.2 MODES AND INDICATORS
4.2.1 AUTO MODE
The Air Quality Sensor measures the ambient air quality. When Auto Mode is activated, the
appliance automatically utilizes the Air Quality Sensor to select the most appropriate fan speed
for the measured air quality in the room.
To turn on Auto Mode, press the Auto Mode Button (the Auto light will illuminate)
If the air quality in the room is Good (Green indicator light), the appliance will operate at a
low fan speed. If the air quality is Excellent (Blue indicator light), the fan may completely stop
running. The appliance will automatically adjust the fan speed according to detected changes
in the air quality.
NOTE: When the humidity level in the room is very high, it is possible that condensation
can develop on the Air Quality Sensor on the side of the appliance. This may cause
the O2+ Source to believe the air quality is lower and cause the fan speed to
operate at a higher level. If the room has very high humidity, you may prefer to run
the appliance in Fan Speed Mode rather than Auto Mode.
4.2.2 NIGHT MODE
If the Source is in AUTO mode and the room has been dark for 3 minutes, the appliance will
automatically switch into Night Mode. In Night Mode, the air quality indicator and control lights will
turn off and the fan speed and noise level are reduced.
Once the room becomes light for 5 minutes or more, the appliance will resume normal light indicators
and operation. You may also press Fan Speed to manually take the unit out of Night Mode.
4.2.3 ECO MODE
If the appliance is operating in either Auto Mode or Fan Speed Mode, you can press the Eco Mode
Button. Eco Mode automatically turns the fan speed to the lowest setting to conserve energy.
All manuals and user guides at all-guides.com
8
Publicité
