YORKVILLE Synergy SA315S Manuel De L'utilisateur page 15

S A B U M P E R 1
Important Safety Considerations!
• Experienced professionals should only carry out rigging.
• Use mounting and rigging hardware that has been rated to meet or exceed the weight being hung.
• Inspect mounting and rigging hardware regularly. Immediately replace any worn or damaged components.
Hanging an Array
1. Attach the main pick-up points from the motor hoist to the SABUMPER1 and raise the bumper off the
ground enough to roll the first row of cabinets underneath it.
2. Cluster the first row of cabinets tightly together directly below the bumper. Slowly lower the bumper
down on top of the cabinets while lining up the RAILS on the underside of the bumper and the RAILS
on the top of each cabinet.
3. Remove the quick pins and LOCKBARS from between each dolly and cabinet and insert the LOCK-
BAR into the RAILS on the underside of the bumper and the top of each cabinet.
REMEMBER TO REPLACE EACH QUICK PIN TO SECURE THE LOCKBARS IN PLACE.
FAILURE TO DO SO COULD RESULT IN THE LOCKBARS SLIDING OUT DURING USE.
4. Once all the LOCKBARS and quick pins are secure raise the bumper up and roll the dollies out of the way.
5. Roll the next row of cabinets into place and repeat the process of lowering the cabinets down onto
each other removing the LOCKBARS and quick pins from the dollies and securing them into the
RAILS between the top and bottom of the cabinets.
To dismantle the array simply reverse the process by lowering the bottom row of cabinet down onto the dollies,
remove the LOCKBAR and quick pins from between the cabinets and secure them into the dollies.
2