Hayward Pool HP50TR Guide D'installation Et D'utilisation page 12

4. USAGE
4.2. Usage of wire controller
4.2.1
Turn ON/OFF the unit
When the unit is off, press the key"
When the unit is on, press the key"
Standinterfaceby
4.2.2
Setting temperature
In the running interface，press"
then press"
save setting parameter but back to the main interface; Attention：If there is no operation for
5s，system would remember parameter setting and back to the main interface. In the main
interface，press"
display is back to the main interface after 10s.
Press" "2s
9
Press"
Press"
"or"
"to increase the temp.value, or press"
"for 2s you can see the outlet temp.The parameter is then flashed and the
Press"
System will save user's
setting and return back
to main interface if there
is no operation in 5s.
Outlet Temp.
"0.5s to turned on the unit;
"0.5s to show down the unit.
"0.5s
"0.5s
Running interface
"then the current mode target-temperature flashes,
"
or " "
Press"
"to decrease it. Press"
" Press" "
Heating/ Cooling
actual water Temp.
"will not
Heating/ Cooling
Target Temp.
Heating/ Cooling
Target Temp.