Satco NUVO S23140 Instructions D'installation

HI-PRO LED CCT & WATTAGE
SELECTABLE LAMPS
Models: S23140, S23141, S23142, S23143, S23144, S23145,
S23146, S23147, S23148, S23149, S23150, S23151, S23152
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Luminaire wiring and electrical parts may be damaged when drilling for
installation of LED retrofit. Check for enclosed wiring and components.
• LED Retrofit installation requires knowledge of luminaires electrical systems.
If not qualified, do not attempt installation. Contact a qualified electrician.
• Install this lamp only in luminaires that have the construction features and
dimensions shown in the photographs and/or drawings and where the input
rating of the retrofit does not exceed the input rating of the luminaire.
• Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation.
• To prevent wiring damage or abrasion, do not expose wiring to edges of
sheet metal or other sharp objects.
• Disable all power to the Luminaire. The lamp holder must be disconnected
from the wiring to the ballast, capacitor, or ignitor. Verify that voltage does
not exceed 277V AC. Please see "Wiring Diagram".
• Failure to follow instructions can result in a damaged product
and will void warranty. It could also result in an electric shock or fire.
IMPORTANT:
• Added weight of the device may cause instability of a free-standing portable
luminaire.
• Installers should not disconnect existing wires from lampholder terminals to
make new connections at lampholder terminals. Instead installers should cut
existing lampholder leads away from the lampholder and make new electrical
connections to lampholder lead wires by employing applicable connectors.
Item # Watts
S23146
S23140 45/36/27 S23147
S23141 45/36/27 S23148
S23142 54/45/36 S23149
S23143 80/63/54 S23150
S23144 100/80/63 S23151
S23145 120/100/80 S23152
INSTALLATION
STEP 1: Turn off the power before installation.
STEP 2: Remove the old Ballast, Capacitor
and Ignitor (if existing).
STEP 3: Make sure Alternating Current Wires
connect to the socket directly. Reattach or
replace ground lead (if necessary).
STEP 4: Select color temperature and
wattage on lamp (Figure A). NOTE: The
lamp is preset to the highest wattage and
color temperature.
STEP 5: Screw the LED lamp into the
corresponding socket. Attach retrofit label
to luminaire.
NOTE: For 100-277 Volts Applications with
two hot leads, connect the second hot lead
to terminal N (L).
© Copyright 2021 Satco Products, Inc. 11/21 v1.6
18/16/12
22/18/16
27/22/18
36/27/18
63/54/45
27/22/18
36/27/18
(L1)
CFL Wiring Diagram
Capacitor
(L1)
HPS/HID Wiring Diagram
Fig. A
Color
temperature
selection
switch
4000K
3000K
Color Temperature
Wattage
selection
switch
WIRING DIAGRAM
Replacing CFL Lamp
Replacing HPS/HID Lamp
Ignitor
5000K
(L1)
Hi–Pro Wiring Diagram
Capacitor Ignitor
(L1)
Hi–Pro Wiring Diagram
Satco Products, Inc.
Brentwood, NY 11717