Electrical Connection; Use In Evacuation Mode; Use In Recycling Mode; Fitting The Hood - De Dietrich DHV7831B Guide D'utilisation

ELECTRICAL CONNECTION

During installation and maintenance ope-
rations, the appliance must be disconnec-
ted from the mains; fuses must be
isolated or removed.
The electrical connections should be
made before the appliance is installed in
its housing.
Check that:
- the electrical installation is sufficiently
rated,
- the supply wires are in good condition,
- the diameter of the wires complies with
the installation requirements.
This appliance is supplied fitted with a
3-core (phase, neutral and earth)
0.75mm H 05 VVF cable. It must be
2
connected to a 220-240V single phase
mains network via an IEC 60083 socket
which must remain accessible after ins-
tallation, in accordance with the installa-
tion rules.
The fuse in your installation must be 10
or 16A. If the mains cable is damaged,
call after-sales service and so avoid any
danger.
If the electrical installation in your home
requires any changes in order to connect
your appliance, contact a professional
electrician.
If the hood malfunctions in any way, un-
plug it or remove the fuse for the circuit
concerned.
The installation must comply with current
regulations for the ventilation of rooms. In
particular, air must not be evacuated into
a duct used to evacuate fumes from ap-
pliances using gas or other fuels. Disused
ducts may only be brought into service, if
approved by a competent specialist. The
evacuation line, whatever its type, must
not emerge in a loft space

- USE IN EVACUATION MODE

You have a duct that leads outside.
Your hood may be connected to it via an
evacuation duct (minimum 125mm dia.,
made of enamelled, aluminium hose or
other non-flammable material). If your
duct is less than 125mm in diameter, you
must change to recycling mode.

- USE IN RECYCLING MODE

You do not have a duct leading to the out-
side.
All our appliances can operate in recy-
cling mode.
Energy saving advice
To obtain the best performance from your
appliance, limit the number of bends and
length of the duct as much as possible.

2.2 - FITTING THE HOOD

The minimum distance between the coo-
king surface (2.1) and the lowest part of
the hood is 65cm. If the instructions for a
hob installed below the hood specify a
distance greater than 65 cm, then that
distance must be applied.
- Install the hook on a suitable place once
the installation height is fixed, and keep it
in line.(2.2)
-
Take out the aluminum filter and install
the carbon filter on both sides of motor.
-
Put the cooker hood on the hook. After
adjusting the position, fix the body with
safety screws and plugs.
19
.