Ltc Audio FREESOUND20 Manuel D'utilisation page 2

Contents of the carton
1x Bluetooth outdoor speaker FREESOUND20
1x USB DC 5V charging lead
1x 3.5mm AUX lead
1x manual
Charging the Bluetooth Speaker
Plug the pin of the USB 5V DC charging lead into the DC socket on the rear side of the
speaker. Plug the other end into a USB port on your computer or any other device allowing
USB charging. The LED on the top of the speaker lights up in red when the unit is charging. It
will shut off when the battery is fully charged.
Location of controls
1. LED indicator light
2.  VOL+ button: Quick press for previous song
Long press to increase the volume
3.   button: 3 sec. press to power ON/OFF
6 sec. press to enter Bluetooth mode
Quick press to pause/play music
4.  VOL- button: Quick press for next song
Long press to decrease volume
5. 5V DC charging socket
6. AUX IN jack
Pairing the speaker with a Bluetooth enabled device
Hold the   button pressed for 6 seconds. A tone will be heard and the LED Bluetooth indicator light will flash slowly in blue.
Keep the speaker and the Bluetooth device within 1m of each other during the pairing process.
Set your mobile phone or other Bluetooth enabled device to search for Bluetooth devices.
If there are no paired devices in range when the speaker is turned on, it will go into pairing mode automatically. If a paired device
is in range, the speaker will connect to it automatically.
When the Bluetooth device finds the speaker, select FREESOUND20 in the list of found devices. If required, enter the password
0000. Select OK or YES to pair the 2 units.
After a successful pairing, a tone will be heard and the Bluetooth LED indicator will flash twice in blue every 5 seconds.
Note: If you want to pair the speaker with another Bluetooth device, you must first unpair the speaker from the current device.
Once the speaker has been unpaired, it will switch automatically into pairing mode.
Operation of the Bluetooth Speaker
Power ON/OFF
Press the   button for 3 seconds.
Volume Adjustment
Hold the  VOL+ button pressed to increase the volume or the  VOL- to decrease the volume.
You can also control the volume via your connected Bluetooth device.
Playing Music
Once you have successfully paired your Bluetooth device with the speaker, press the PLAY button on your Bluetooth device. Once
the playback has begun, you can control the music from your connected device (if it has AVRCP profile).
Play/Pause
Press shortly the  button to pause the music. Press again to resume playback.
Skipping songs
Press shortly the  VOL- button to skip to the next song or the  VOL+ button to skip back to the previous song.
GB
BLUETOOTH OUTDOOR SPEAKER
2