Publicité
Les langues disponibles
Les langues disponibles
2. Check the standby status after plugging into an electrical outlet
The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink,
press the ID SET button on the back of the Wireless Receiver Module with a pen tip for 5~6 seconds
until the LINK LED indicator blinks (in Blue).
3. Configure "ID SET" using the Soundbar's remote control
Press and hold the Up button on the remote control for at least 5 seconds.
• The ID SET message appears on the display of the Soundbar for a moment, and then it disappears.
• The Soundbar will automatically power on when ID SET is complete.
CAUTION
• If your Soundbar was playing music when it connects to the SWA-8500, you may hear some
stuttering from the woofer as the connection finalises.
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3
L
R
5 Sec
SURROUND SPEAKERS OUT
ID SET
SPEAKER IMPEDANCE : 3
ID SET
POWER
POWER
5 Sec
ENG - 9
STANDBY
LINK
STANDBY
LINK
Blue blinking
ID SET
Publicité
