warmhaus Dallas DSF-1/0302 Instructions Importantes – Mode D'emploi page 3

23. Faulty wall outlet connections may cause the wall outlet to overheat. Be sure that the
fireplace plug properly fits into the outlet before each use. During use, make sure the
fireplace plug does not overheat. If necessary, have a qualified electrician check and / or
replace the wall outlet.
24. Do not place the fireplace near a bed for objects such as pillows or blankets can fall off the
bed and be ignited by the fireplace.
25. Never clean this fireplace while it is plugged in. To disconnect, turn control to OFF, then
remove the plug from the outlet. Never pull the cord. Always hold the plug firmly and then
remove from the outlet.
26. This fireplace is intended for supplemental heat and / or decorative purposes. Continuous
use for several hours can impact the performance and life of the fireplace.
27. It is not intended to be used in commercial, industrial or agricultural settings.
28. Do not use outdoors.
Getting Started

Remove the fireplace from the box.

Remove the packaging. Place it inside the box or safely dispose elsewhere.
Package Contents

Electric Fireplace

Instruction Manual
Features

Floor standing electric fireplace

Contemporary & portable design

Dual heat settings (700Watts / 1400Watts)

Realistic wooden log flame effect

Flames operate with & without heat

Adjustable flame brightness

1400 Watts

Built-in overheating protection, auto safety shut-off

Cool touch housing

No assembly or hardware needed. Simply plug & heat
Quick Reference Guide

Prior to installation, please ensure that the voltage and capacity of your power outlet is
compatible with your fireplace.

Your fireplace may emit a slight, harmless odor during its first use. This odor is a normal
reaction caused by the initial heating of internal fireplace parts and it will not occur again.

It is normal for fireplace to make a rattling sound for a short duration of time during its
first use.

If your fireplace does not emit heat, please ensure the fireplace switch is on. For further
information, please refer to the Troubleshooting section of this manual.
3