Campbell Scientific CR200 Série Manuel D'utilisation page 7

Chapitre 5. Déclarations dans un programme
Alias -----------------------------------------------------------------------------------------------------------5-1
Const ----------------------------------------------------------------------------------------------------------5-1
Dim ------------------------------------------------------------------------------------------------------------5-2
Public----------------------------------------------------------------------------------------------------------5-2
Units -----------------------------------------------------------------------------------------------------------5-3
Sub, Exit Sub, End Sub -------------------------------------------------------------------------------------5-3
Chapitre 6. Déclarations du tableau de sauvegarde et instructions de
traitement de sauvegarde
6.1 Déclaration du tableau de sauvegarde --------------------------------------------------------------------6-1
DataTable (Name, TrigVar, Size) -------------------------------------------------------------------------6-1
6.2 Modifications des conditions de basculement (Trigger modifiers)------------------------------------6-2
DataInterval (TintoInt, Interval, Units) -------------------------------------------------------------------6-2
6.3 Instructions de sauvegarde ---------------------------------------------------------------------------------6-2
Average (Reps, Source, DisableVar)----------------------------------------------------------------------6-2
ETo (Temp, RH, u2, Rs, Longitude, Latitude, Altitude, DisableVar) --------------------------------6-3
EtoDaily (Temp, RH, u2, Rs, Longitude, Latitude, Altitude, DisableVar)---------------------------6-3
FieldNames « list of fieldnames » -------------------------------------------------------------------------6-4
Maximum (Reps, Source, DisableVar, Time)------------------------------------------------------------6-5
Minimum (Reps, Source, DisableVar, Time) ------------------------------------------------------------6-5
Sample (Reps, Source) --------------------------------------------------------------------------------------6-6
StdDev (Reps, Source, DisableVar) -----------------------------------------------------------------------6-6
Totalize (Reps, Source, DisableVar) ----------------------------------------------------------------------6-6
WindVector (Speed/East, Direction/North, DisableVar, SensorType, OutputOpt) -----------------6-7
Valeurs brutes mesurées :-----------------------------------------------------------------------------------6-8
Calculs :-------------------------------------------------------------------------------------------------------6-8
Chapitre 7. Instructions de mesure
7.1 Mesures de tension ------------------------------------------------------------------------------------------7-1
7.2 Demi pont ----------------------------------------------------------------------------------------------------7-1
7.3 Excitation / Sortie de tension en continu -----------------------------------------------------------------7-1
7.4 Mesure ne nécessitant pas de capteur ---------------------------------------------------------------------7-1
7.5 Port de contrôle E/S -----------------------------------------------------------------------------------------7-1
VoltSE (Dest, Reps, SEChan, Mult, Offset) -------------------------------------------------------------7-2
ExDelSE (Dest, Reps, SEChan, ExChan, ExmV, Delay, Mult, Offset) ------------------------------7-2
Therm109 (Dest, Reps, SEChan, ExChan, Mult, Offset)-----------------------------------------------7-3
ExciteV (ExChan, ExmV,) ---------------------------------------------------------------------------------7-4
Battery (Dest) ------------------------------------------------------------------------------------------------7-4
AnalogPortGet (Dest, SEChan) ----------------------------------------------------------------------------7-5
AnalogPortSet (SEChan, State) ----------------------------------------------------------------------------7-5
PeriodAvg (Dest, SEChan, PAOption, Cycles, Timeout, Port, Mult, Offset)------------------------7-5
PortGet (Dest, Port) -----------------------------------------------------------------------------------------7-6
PortSet (Dest, State) -----------------------------------------------------------------------------------------7-7
PulseCount (Dest, Pchan, PConfig, POption, Mult, Offset)--------------------------------------------7-7
SDI12Recorder (Dest, OutString, Multiplier, Offset)---------------------------------------------------7-8
SwBatt---------------------------------------------------------------------------------------------------------7-10
¡¡¡