Qilive Q.5673 Manuel D'utilisation page 6

2. DESCRIPTION
EN
1. Eject button
2. Speed selector knob
3. Turbo button
3. SETTING UP
Before using your mixer for the first time, wash the whisks in warm, soapy water. Rinse them, then
dry them. Check that the speed selector is in the zero position and the appliance is disconnected
from the mains supply. Insert one whisk at a time, placing the tip of the shaft into one of the slots
on the mixer. Turn the whisk slightly and push it until it snaps into place.
4. USING THE APPLIANCE
Before using the mixer, check that the speed selector is in the 0 position.
Dip the whisks into the product to be mixed.
Turn on the mixer and adjust the speed using the speed selector.
Start by mixing at low speed, then gradually increase to reach the desired speed.
During operation, you can press the speed selector to select the desired setting. There are 5
speeds, from position 1 (slowest), to position 5 (fastest) and a TURBO mode.
Hold down the TURBO button to get a speed about 40% faster than the selected one. Release it
to return to the selected speed.
Caution: Never place any metal knives, spoons, forks or other utensils in the bowl during
operation.Never press the eject button while the mixer is operating.
Guide the mixer gently on the edges and in the centre of the bowl, working in the same direction.
Always start by mixing the contents of the bowl at low speed. Then gradually increase the speed
as described in the recipe.
If you wish to add ingredients, set the speed selector to position 0 and put the mixer down. Ensure
that the whisks are placed above the bowl to avoid splashes.
IMPORTANT: The maximum duration of continuous operation is 5 minutes, then turn the mixer off
and let it rest for at least 20 minutes.
When the mixture is ready, set the speed selector to position 0, gently lift up the whisks and turn
off the appliance, and then use a spatula to remove any mixture that has stuck to the whisks.
Never place your fingers directly on the whisks.
Ensure that the appliance is turned off before removing the whisks fully from the bowl.
To remove the attachments, hold the whisks in one hand and press the eject button firmly with the
other hand while pulling on the whisks.
5. CLEANING AND MAINTENANCE
Wash the whisks before and after each use.
Make sure to dry them thoroughly after washing. Unplug the cable from the power socket, then
clean the mixer with a damp cloth and wipe it.
DO NOT IMMERSE THE MIXER IN WATER. Doing so may cause electric shock, injury, or product
damage.
Avoid using abrasive cleaners that may damage the casing of your mixer. The mixer motor has
4. Whisks
5. Dough hook
6