Venmar VBNDH1 Manuel D'installation, D'entretien Et D'utilisation page 10

5 ] Remove the parts bag, taped on the inner back of hood, near the left corner. Remove the EZ1
6 ] Remove Electrical Power Cable Knockout from top (vertical wiring) or back (horizontal wiring)
7 ] Remove 3 screws retaining the recirculation cover plate to the hood. Discard this plate with
10
brackets from inside the hood by cutting off the tie wrap. Discard the tie wrap.
PARTS BAG LOCATION
of hood. For knockout removed from back of hood, install an appropriate strain relief,
1/2" diameter (not included). For knockout removed from top of hood, the strain relief will be
installed later.
ELECTRICAL
POWER CABLE
KNOCKOUT
NON-DUCTED INSTALLATION ONLY
its screws. Peel off and discard the membrane covering the recirculation grille, ensuring
the openings are totally cleared.
RECIRCULATION
COVER PLATE
SCREWS
EZ1 BRACKETS