Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION - Transmitter (TX) LED's
SYNC
REC
Mode
GREEN
Blink
LED +
GREEN
Vibration
On
Vibration
(1 time
only)
Vibration
(1 time
only)
LED
Vibration
Off
LED Off
No
Vibration
No
LED OFF
(GREEN OFF
LED
Notes:
1) After synchronization, the mode goes back to its previous selected mode.
2) When TX is OFF and inserted into RX, there will be no synchronization.
3) If the TX goes out of normal range, it will resume its previous status when
it comes back into range.
5
Battery
Out of
Status
Range
Mute
TALK O
RED
RED
N
Blink
On
REC
Off:
GREEN
On
Vibration
Vibration
(3 time
(2 times
REC:
per second)
per 3
ORANGE
seconds
Blink
Vibration
Vibration
(3 time
(2 times
per
per 3
second)
seconds)
LED Off
LED Off
No Vibration
,
ORANGE
OFF,
RED
OFF)
Quick Set up and Operation
Synchronization of Transmitter and Receiver
The synchronization only needs to be performed the first time a system is
used, or another transmitter is used with a receiver previously synced.
Do not perform the sync operation multiple times; it only needs to be done once
successfully.
1)
Turn the transmitter power switch to ON and select the operation mode with
MODE switch and place the transmitter into the receiver.
2)
When synchronization is completed, then STATUS LED will stop flashing. If
vibration mode is enabled, then it will vibrate once.
Normal Operation
1)
With the transmitter synced, remove it from the receiver, plug in the lapel
microphone (if used) and place the transmitter into the leather pouch on user's
belt.
Vibration
2)
When user removes transmitter from the receiver, STATUS LED for each
(1 time
transmitter and receiver will light constant green. To start recording, press the
per 3
REC button and the LED beneath REC button will blink red.
seconds)
3)
If the recording command from VPU is received, recording will start and the LED
beneath REC button will flash red.
a recording was NOT STARTED, the REC button will NOT flash red.
Vibration
4)
If the stop command from VPU is received, recording will end and the LED
(1 time
beneath REC button will be off.
per 3
seconds)
Out of Range
1)
The transmitter will alert user by flashing the RED LED of STATUS.
2)
The transmitter needs to move closer to the receiver and the link will be re-
LED Off
established without physically "re-syncing" the TX with RX when user returns to
normal range. STATUS LED will light constant green when link is back to
normal range.
Mute Button
1)
Mute button can be used to mute the user's audio stream when needed.
2)
In recording mode; press mute button on the transmitter, then ORANGE LED of
STATUS will flash.
Low Battery Warning
1)
If low battery indicator (RED) starts flashing, return the transmitter to the
receiver to be fully charged.
2)
The charge LED indicator will light constant green when the unit is fully
charged.
If the record command was not received and
6
Publicité
