Hewlett Packard StoreOnce 3100 System Manuel D'installation page 2

Step 3: Install the unit in the rack
CAUTION: Use extreme caution when
installing and pulling units from the rack; they
can slip and fall, causing damage to the
StoreOnce System or injury. Hewlett Packard
Enterprise is not responsible for any damage
or injury caused by the mishandling of the
StoreOnce System.
Always use at least two people to lift and
locate an enclosure into the rack.
There is a label on top of the appliance that shows
the default network name and MAC address of the
1GbE network port 1 of the unit and login
information for the iLO4 management port. Before
you install the appliance in the rack, make a note
of this information.
Network
name:___________________________________
MAC
address:_________________________________
iLO network
name:________________________________
iLO
password:_________________________________
1. Install the rail kit and install the StoreOnce
System and cable management arm into the
rack. For more information, see the installation
instructions that ship with the rail kit.
2. Attach the security bezel.
NOTE: The key to lock the bezel is
attached to the back of the security
bezel. One key is supplied.
Figure 2 Attaching the security bezel
3
2
1 Attach right edge of
bezel
3 Attach left edge of
bezel
Step 4: Connect power cables
Figure 3 Connecting the power cables
4
1
2 Insert key
4 Lock bezel with key