MegaGroup hydro-pro Inverter 07 Mode D'emploi page 28

For example, click
Its default value is '0'. If you want the water pump not to start or stop together with the compressor, and always running,
you can select the option "1", then click 'OK'. So the P3 value will be changed to '1'.
6.2.4 Users' parameter setting codes
Code Description
P0 Forced defrost selection
Water pump
P3
selection
T1 Water in temp.calibration
P7
setting
P14 Reset Factory Parameter
P16 Model Code
6.2.5 Timer ON/OFF
Firstly, slide the spot from the left
Then set the time that you want your heat pump to be off, lastly click 'OK' to save the setting and exist.
of P3, it will go to next setting interface.
Scope
0-1
running
0-1
-9～9
0-1
to the right
Default
value
1:Forced defrosting mode. 0:Normal mode.Once forced defrost
0
exits, P0 automatically turns to 0.
1: Always running
0
0: Depends on the running of compressor
T1 Water in temp.calibration setting, normally no need to set this
0
parameter,keep default value 0 .
0: Default
0
1: Reset factory parameter（P0，P3，P7etc）
Sent from PCB
to activate the Timer OFF (for example)
25
Remarks