Geberit Bambini 577660000 Manuel D'entretien page 18

EN
Operation
Troubleshooting
The operator can perform the following measures to rectify malfunctions:
• cleaning the tap aerator
• cleaning the basket filter
• replacing the batteries
• setting the detection distance of the IR sensor
These measures are described in the operation manual 968.598.00.0.
Malfunction
Water jet too weak.
Flush does not actuate.
Water runs continuously.
Unwanted flow of water, either
too soon or delayed.
Water drips from the tap
housing.
Red LED flashes during flush
actuation.
LED lights up, flush does not
actuate.
18
Cause
Tap aerator dirty
Basket filter clogged
Pipe pressure too low
Pipe pressure too low
Network failure
Battery dead
Solenoid valve defective
IR sensor defective
Solenoid valve defective
IR sensor defective
Pipe pressure too high
IR window is dirty or wet
IR window scratched
Detection distance of the IR
sensor not set correctly
Solenoid valve does not close
properly
Battery almost dead
Battery dead
Rectification
▶ Clean the tap aerator. → See operation
manual 968.598.00.0.
▶ Clean the basket filter. → See
operation manual 968.598.00.0.
▶ Test pipe pressure (1–8.5 bar).
▶ Test pipe pressure (1–8.5 bar).
▶ Check the power supply.
▶ Replace the battery. → See operation
manual 968.598.00.0.
▶ Replace the solenoid valve. → See
"Replace the solenoid valve", page 19.
▶ Replace IR sensor. → See "Replacing
the IR sensor", page 24.
▶ Replace the solenoid valve. → See
"Replace the solenoid valve", page 19.
▶ Replace IR sensor. → See "Replacing
the IR sensor", page 24.
▶ Test pipe pressure (1–8.5 bar).
▶ Clean or dry the IR window.
▶ Contact a skilled person.
▶ Set detection distance. → See
operation manual 968.598.00.0.
▶ Clean or replace the solenoid valve. →
See "Replace the solenoid valve",
page 19.
▶ Replace the battery. → See operation
manual 968.598.00.0.
▶ Replace the battery. → See operation
manual 968.598.00.0.
9007207535917323 © 02-2022
970.429.00.0(01)