Publicité
Les langues disponibles
Les langues disponibles
Low pressure breathing air compressors supply air for low pressure constant flow type respirators only.
Oilless compressors produce no oil mist, oil vapor, or carbon monoxide (CO). High temperature alarms and oil/
water filters are not required as they are with conventional air compressors. Breathing air compressors do not
significantly change the air quality of the ambient air and are not designed to filter carbon monoxide or other toxic
gases. An optional carbon monoxide monitor is available where required. Clean breathable air must be provided
to the breathing air compressor inlet at all times. Note: Tight fitting constant flow respirators require 4 cfm (115
lpm) minimum flow rate at the manufacturer's stated pressure. Loose fitting hoods require at least 6 cfm (170
lpm) per respirator.
1. Do not use kerosene or any oil based solvents for cleaning these compressors.
2. Do not lubricate oilless breathing air compressors.
3. Do not run these air compressors in the wrong rotation; check the rotation arrow on the compressor if
you are rewiring the electric motor. Disconnect the power source before servicing the electric motor.
4. Do not run this compressor without connecting at least one hose and respirator to the manifold quick
disconnect assembly.
5. Compressors must be used with constant flow, low pressure respirators only. Pressure demand
respirators will not operate on this compressor.
6. The breathing air compressor units can not be operated in an area that is Immediately Dangerous to Life
or Health (IDLH).
7. The air inlet to the breathing air compressor must be located in a clean air environment where
breathable air can be assured at all times. Up to 150 ft. (46 m) of extension tubing can be used to
remote the intake snorkel. Contact the factory for assistance in determining the proper size tubing for
remote intake setup.
8. Vortex tubes require high pressure air, 60 - 100psi (4,1 - 6,9 bar), and will not operate on these
breathing air compressor systems. Use Air Systems' Cool-Box
BACB-196LP. Provides approximately 50
9. Pump surfaces can become very hot during operation. Do not touch these surfaces until the unit has
been shut off and allowed to cool.
netzerotools.com
-3-
OVERVIEW
Caution: Read and Follow All
Instructions
output air temperature.
o
netzerotools.com
for air cooling; order Model
TM
Publicité
