Publicité
Les langues disponibles
Les langues disponibles
Further information
Important Notes:
G
a
s
y c
n i l
d
r e
n
t o
p
o r
designed to operate with a cylinder size no
more than Ø 31.8 x 58 cm.
This appliance requires a 15 kg butane LPG
cylinder or a 13 kg propane LPG cylinder.
Gas regulator should be the correct one and
be set according to specific gas category
(see Technical data on page 3).
Gas regulator should be approved according
to EN 16129:2013 with proper capacity (g/h),
pressure,working temperature and inlet +
outlet
connection
destination.The regulator illustrated on the
manual is for United Kingdom, the regulator
in your country maybe different with the one
on the illustration.
Flexible gas rubber pipe should be approved
according to 16436-1:2014 with proper inner
Ø to match pipe holders of gas circuit and
gas
regulator,
pressure
tempera-ture.
The length of the hose is 0.41 m and it
should not exceed 0.7 m. The hose shall be
readily visible across its entire length for
inspection after installation.
The injector in this appliance is not
removable and the injector is only assembled
by manufacturer. This appliance is forbidden
to convert from one gas pressure to another
pressure.
To check that the regulator seal is correctly
fitted and able to fulfill its function.
To check the hose at least once per month，
each time the cylinder is changed，or each
time before long time no use. If it shows signs
of cracking, splitting or other deterioration it
shall be exchanged for new hose of the same
length and of the equivalent quality;
v
d i
e
d
T .
h
e
a
p
p
a i l
n
c
e
for
the
country
and
working
user should be familiar with the operation
of the products .
The hose and regulator assembly must
s i
conform to local standard codes
Danger:
You must have the proper regulator and
cylinder in order for the appliance to operate
safely and efficiently. Use of an incorrect or
faulty regulator is dangerous and will invali-
date any warranty.
Connect LP Gas cylinder
of
Before connecting, be sure that there is no
debris caught in the head of the LP tank,
head of the regulator valve or in the head
of the burner and burner ports.
Connect gas line to tank by turning knob
clockwise until it stops, make sure that the
tube is not subject to twisting.
After connecting to gas cylinder, a leak test-
ing is necessary.
Disconnect LP Gas cylinder
Before disconnecting make sure the LP gas
tank valve in "CLOSED". Disconnect gas line
from LP gas cylinder by turning knob
counterclockwise until it is loose.
For storage and cylinder exchange, discon-
nect hose at the cylinder only, DO NOT
disconnect hose from appliance.
To change the gas cylinder in an amply ven-
tilated area, away from any ignition source
(candle, cigarettes, other flame producing
appliances...).
14
GB
Publicité
