Water Ace RSP7 3/4 HP Manuel D'installation page 4

SWIMMING POOL PUMP INSTALLATION
General Tools and Materials Needed
• Electrical cable with ground wire
• Ground fault circuit breaker
• Rigid 1-1/2" PVC pipe and fittings or reinforced flex hose and
hose clamps
• Pump
• Filter
• Backwash valve (not required on cartridge filter)
• Shut-off valves
• Hacksaw with 24-tooth blade for cutting plastic pipe
• Knife or round file for smoothing inside of plastic pipe connections
• Screwdriver, pipe wrench, adjustable wrench
• PVC cleaner and adhesive
• Hose clamp fittings (required only for flex hose)
TYPICAL INSTALLATION DRAWING
Filter: Cartridge filters require no backwash valve.
Sand or diatomaceous earth filters require a
backwash valve.
Backwash Valve
Optional Shut-O Valves
can be installed in the
lter inlet and outlet lines
to allow isolation of the
lter for service.
23833A157
Pump Discharge Line
Circulation
Pump
Return Line
Direction of Flow
STEP
1
Locate pump and filter on a solid level ground. Make
sure pump is protected from the weather and pool
splash. (Water should not come in contact with motor.)
STEP
2
Connect the suction line from the pool skimmer and/or
drain to the pump inlet. A shut-off valve is required on
above ground pools.
STEP
3
Connect the discharge line from the pump to the
filter inlet.
STEP
4
Connect the return line from the filter outlet to the
swimming pool return inlet.
STEP
5
Connect the electrical cable from the pump to a ground
fault circuit breaker. Make sure power is off before
connecting the wires. (SEE ELECTRICAL INFORMATION,
PAGE 5).
Pump Suction Line
Skimmer
Inlet Line
from Skimmer
Main Drain Sump
4
At Least 3 Feet
Suction Outlets (Main Drains)
with IAPMO Certified Anti-
entrapment Covers or Suction
Fittings, screw-fastened.
No valves between
Tee and Main Drains
Valves OK
between Tee
and Pump
Main
Drain
Sump