iBACheck AA1661 Manuel De L'utilisateur page 3

English
Insert the provided Mouthpiece into the gas inlet located on
top of the LCD screen.
Mouthpiece
inlet
Esc
Pressing the
the alcohol mode
an approximate 20seconds.
If the machine has already turned on, just press
activate sensor pre-heating,
start to counts down.
(1) When count down to zero, BLOW flashes with beep tone. It is ready
to start the test.
(2)
Manual test:
During this 6s auto detect
and please blow through the mouthpiece steadily and continuously
for approximately six seconds. While blowing, a long beep will be
heard until the beep tone stops. Sampling finishes and the test result
will be shown on the display immediately.
(3) Active test
During this 6s auto detect
a long beep will be heard and please keep blowing. When the beep
tone stops, sampling finishes and the test result reading will be shown
on the display immediately.
If there's no alcohol concentration detected within 9 seconds when
blowing, the machine will also take the samples and show the result
automatically.
START key 1second to turn on the power and enter into
DAC
There will have a
period, press the START key, BLOW lit
period, If alcohol concentration is detected,
, sensor pre-heating will be activated for
PH will flashes for 4 times and then
6s. auto flow detect period,
3
LCD
Mem
START
START key once to