Publicité
Les langues disponibles
Les langues disponibles
▪
Check that all fixing screws are properly screwed.
Regular inspection is important to ensure the safety and
performance of the power tool;
▪
After the accessories' assembly and before using the
power tool, test it at full speed with no load for a while.
Check that all moving parts rotate smoothly, without
abnormal noises or sparks on the carbon brushes;
▪
Check that the safety devices are in perfect condition
and work properly. Never use the power tool if the safety
devices are missing, inhibited, damaged or worn out;
▪
If the "ON/OFF" switch is damaged or does not allow the
tool operation to be controlled, it must be repaired or
replaced in order to avoid unintentional start-up from
the power tool.
Perform all adjustments and work necessary for the correct
assembly of the power tool if you have any questions or
difficulties, contact your official dealer.
Keep third parties away from the power tool's area of
operation. Never work while animals or people,
especially children, are in the danger zone.
Keep the work area clean, organized and well lit (250 to 300
lux light), thus decreasing the risk of accidents.
Always wear personal protective equipment and clothing.
Wearing a visor or goggles, dust mask, hearing protection,
anti-slip safety shoes, long-sleeved clothing, gloves and
helmet properly reduces the risk of injury.
Clothing worn during use of the machine must be
adequate, tight and closed, for example, a work boiler suit.
Do not wear loose clothing or jewelry. Keep hair, clothing
and gloves away from moving parts.
The use of the power tool causes high load of
vibrations which can cause damage to the
circulatory and nervous systems, especially in people with
circulatory disorders. Seek medical attention if symptoms
occur that may be caused by vibrations. These symptoms,
which occur mainly in the fingers, hands or wrists, include,
for example, loss of sensation, pain, muscle weakness,
discoloration of the skin or unpleasant tingling.
When operating the machine, plan breaks and avoid
operating the vacuum/blower for long periods of time.
Permanent vibrations are harmful to health.
The control and safety devices installed in the power tool
must not be removed or inhibited.
The following precautions and procedures should also be
followed to avoid accidents:
▪
When using the vacuum/blower, place yourself in a
stable position and always keep your balance. Hold the
blower firmly to ensure continuous operation and
withstand unexpected situations.
Unplug the power cord before cleaning, adjustment, repair
or maintenance work.
Replace worn out or damaged parts immediately so that the
power tool is always operational and in a safe operating
condition.
Cleaning:
The power tool must be carefully cleaned after each use.
Do not use aggressive cleaning agents. These agents may
damage plastics and metals, compromising the safe
operation of the power tool.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Keep all nuts and screws well tightened in order to ensure
a safe operation.
If any components or safety devices are removed for
maintenance
works,
immediately.
Use only VITO-approved attachable tools for this machine
or technically identical parts. Otherwise, it may result in
personal injuries or damages to the vacuum/blower. If in
doubt, lack of knowledge or resources, you should contact
an official dealer.
they
must
be
repositioned
Publicité
