Fellowes AeraMax DX55 Manuel D'instructions page 3

SAFETY INSTRUCTIONS/WARNING
WARNING: Follow the instructions in this manual to reduce the risk of electric shock, short circuit, and/or fire:
• Do not repair or modify the unit unless specifically recommended in this manual. All repairs should be
completed by a qualified technician.
• Do not force the plug into an electrical outlet.
• Do not alter the plug in any way. If the plug does not fit into the outlet, reverse the plug. If it still does
not fit, contact a qualified technician to install a proper outlet.
• Do not use if the power cord or plug is damaged or the connection to the wall outlet is loose.
• Use AC 100-240V only.
• Do not damage, break, forcefully bend, pull, twist, bundle, coat, pinch, or place heavy objects on the
power cord.
• Periodically remove dust from the power plug. This will reduce the chance that humidity will
accumulate, which increases the risk of electric shock.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard
• Remove the power plug from the outlet before cleaning the unit. When removing the power plug, grasp
by holding the plug itself, never hold by the cord.
• Remove the power plug from the outlet when the unit is not in use.
• Do not handle the power plug with wet hands.
• Do not operate the unit when using indoor smoke-generating insecticides.
• Do not clean unit with benzene or paint thinner. Do not spray insecticides on the unit.
SET-UP AND OPERATION
NOTE: follow these instructions for best results
Place unit at least ½ meter from the wall. Keep unit away from drafty areas. Keep curtains
away from unit, as they may interfere with air intake/outlet. Place unit on a stable surface with
plenty of air circulation.
1. Remove protective film from the control panel.
2. Pull out drawer.
3. Remove bag from filters. Place filters back in unit.
4. Insert Carbon Filter first and then True HEPA Filter.
5. Fully insert drawer into unit until click is heard.
6. Plug in the power cord to a wall outlet.
7. Turn unit on. Unit will beep.
For approximately the first 4 minutes after turning the unit on, the indicators will flash while
the unit measures air quality.
CARE AND MAINTENANCE
CLEANING:
Clean unit as necessary by wiping with a dry, soft cloth; for stubborn stains, use a warm, damp cloth. Do not use volatile fluids such as benzene, paint thinner, or scouring powder, as they may
damage the unit surface. Keep the unit dry.
TROUBLESHOOTING: Solutions to common problems
Review this list before you call for service. This list covers problems that are not the result of defective materials or workmanship.
PROBLEM:
The unit leaves smoke and odors in the air.
The unit seems to produce odors.
The unit makes a faint ticking sound.
The unit interferes with radio or television reception.
The True HEPA and Carbon Filter indicators remain lit after replacing the
True HEPA and/or Carbon Filter.
The PlasmaTRUE™ icon is not illuminated.
The wrong filter replacement light was reset.
• Do not use the unit where it is humid or where the unit may get wet, such as in a bathroom.
• Do not insert fingers or foreign objects into the air intake or outlet.
• Do not use the unit near flammable gases. Do not use near cigarettes, incense, or other spark-
creating items.
• Unit will not remove carbon monoxide emitted from heating appliances or other sources.
• Do not block the intake or outlet vents.
• Do not use near hot objects, such as a stove. Do not use where the unit may come into contact
with steam.
• Do not use the unit on its side.
• Keep away from products that generate oily residue, such as a deep fryer.
• Do not use detergent to clean the unit.
• Do not operate without a filter.
• Do not wash and reuse the True HEPA Filter.
• Do not run power cord under carpets or cover with throw rugs.
• When moving machine, always lift using handle.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
FILTER REPLACEMENT:
The replacement filter indicators will signal when to replace the True HEPA Filter and/
or Carbon Filter. The replacement period will vary depending on the hours of use and
air quality. However, under normal usage, most True HEPA Filters need to be replaced
annually, and Carbon Filters every three months.
Do not wash and reuse the True HEPA or Carbon Filters—they will not work effectively.
Only use Fellowes brand AeraMax™ replacement filters.
Before replacing any filters, make sure to remove the power plug from the
WARNING:
wall outlet.
FILTER INDICATOR RESET:
1. Be sure that the drawer is closed.
2. Turn on the unit.
3. Locate the filter replacement icon on the display panel.
4. Touch and hold the filter replacement icon for 3 seconds. HEPA Filter icon will flash
amber. Touch filter icon area to alternate between HEPA and Carbon.
5. Once desired filter is illuminated, touch and hold for 3 seconds. A short beep will be
heard and the light should turn off. Repeat process for each filter as needed.
POSSIBLE SOLUTION:
Make sure the sensor is not blocked or clogged. Move the unit closer to the offending odors. Replace the filters as needed.
Replace the filters as needed.
This indicates that the PlasmaTRUE™ function is working.
Because this unit radiates radio frequency energy, we suggest you try one or more of the following:
- For better reception, adjust the television/radio antenna.
- Move the unit away from the affected television/radio.
- Plug the unit power cord into an outlet different from the television/radio power cord.
Repeat filter light reset instructions from the Set-Up and Operation section.
Touch and hold PlasmaTRUE™ icon for five seconds until unit beeps.
In the case of unintended filter reset, repeat the filter reset procedure from the Set-Up and Operation section within 5
minutes of unintended reset. The filter counter and indicator will return to the status previous to the reset.
3