Publicité
Les langues disponibles
Les langues disponibles
SPRAYER COMPONENTS & USE INFORMATION, Continued
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft (A). To
install the pump handle place the handle (C) over the shaft (A) aligning the
pump handle holes and shaft holes. Slide the bolts (B) through the aligned
holes as shown in figure 3. Tighten nuts (D) to bolts. There are holes in the
pump handle to allow for either left (fig.2-4) or right (fig.5) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt
INSTALLING THE SHOULDER STRAP
The top of the shoulder straps are attached to the tank.
Attach the lower end of the straps by clipping the strap hooks
to the metal frame between where the frame exits the tank
and curves around.
WAND HOLDER
The wand easily snaps into
handle.
Pump
Handle
Figure 2
Line up holes
Figure 5
Right Hand
3E
A. Pump Shaft
Pump
Shaft
Figure 3
Slide bolts through holes
Completed Assembly
D. Nuts
B. Bolts
C. Pump Handle
Publicité
