Fenton AV460 Manuel D'instructions page 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the device can be irreparably damaged. The product must also be
directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
GENERAL
1. Microphone volume
Adjust the volume of the microphones.
2. Play
Play the song from your USB or SD card
3. Prev
Select the previews track on your USB or SD card
4. Next
Select the next track on your USB or SD card
5. Repeat
put the playing song on repeat from your USB or SD
card
6. Mode
Switch between different modes
7. Volume control
Adjust the output level of amplifier.
8. Power switch
Press the switch to turn the amplifier on/off.
9. M. Bass
Adjust the bass of your microphone input
10. M.Treble
Adjust the treble of your microphone input
11. Echo
Add echo effect on your microphone sound.
12. MIC 1
Input 6.35mm (1/4") jack input for microphone.
13. MIC 2
Input 6.35mm (1/4") jack input for microphone.
14. Delay
Adjust the delay effect
15. Bass
Adjust the bass of your main output.
16. Treble
Adjust the treble of your main output.
17. USB and SD port -
Insert your USB devices or SD card into these slots.
18. Aux input
input of a line signal
19. Line Stereo output
20. Speaker output
21. DC 12V Input
BT CONNECTION
First turn on the amplifier, press the "MODE" button until BT LED lights up. Then use your mobile or other BT device and search
the amplifier. When you find "AV460" then connect, no password needed. The amplifier is only discoverable when input selected
BT.
4