Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Symptom
Cause
No power.
The power cord is disconnected.
The battery is discharged.
The power is on,
No disc is inserted.
but the unit does
The operation mode is not select-
not work.
ed correctly.
No picture.
The TV is not set to receive the
signal from the unit.
The video cable is not connected
securely.
The LCD mode is set to [Off].
No sound.
The equipment connected with
the audio cable is not set to
receive the signal from the unit.
The volume is set to minimum.
The AUDIO options are set to the
wrong position.
The unit does
An unplayable disc is inserted.
not start play-
back.
The rating level is set.
The remote
The remote control is not pointed
control does not
at the remote sensor on the unit.
work properly.
The remote control is too far from
the unit.
17
DP372D-P_ANGAFLK_ENG_MFL4734975017 17
DP372D-P_ANGAFLK_ENG_MFL4734975017 17
Specifications
Correction
General
Power requirements
Plug the power cord into the wall
Power consumption
outlet securely.
External Dimensions
Recharge the battery.
Net Weight (Approx.)
Insert a disc.
Operating temperature
Operating humidity
Use MODE button to select the
Laser
operation mode. (Page 7)
Signal system
Select the appropriate video input
Connectors
mode on the TV.
Audio/Video Output
Connect the video cable securely.
- Video: 1.0 V (p-p), 75 Ω, sync negative
- Audio: 1.5 Vrms (1 KHz, 0 dB)
Select a LCD mode other than
Earphone terminal
[Off].
Antenna Input
Channel coverage
Select the correct input mode of
the audio amplifier.
Liquid Crystal Display
Panel size
Use the volume controller to
Projection system
adjust the volume.
Driving system
Set the AUDIO settings to the
Resolution
correct position.
Accessories
Insert a playable disc. (Check the
• RCA Video/Audio cable
disc type and regional code.)
• AC Adapter (MPA-630)
• Automotive Adapter (DPDC1)
Change the rating level.
• Remote Control
Point the remote control at the
• Battery for Remote Control (Lithium Battery)
remote sensor of the unit.
• Antenna Cable
• External Antenna Cable
Operate the remote control closer
• Carrying Bag
to the unit.
• Headrest Mounting Bracket
Designs and specifications are subject to change without
prior notice.
DC 12V
12W
207 x 39 x 168 mm (W x H x D)
0.85kg
5 °C to 40 °C
5 % to 90 %
Semiconductor laser
PAL
ø3.5mm mini jack x 1
ø3.5mm stereo mini jack x 2
75 ohms (VHF / UHF)
Analog (VHF/ UHF): 1-125
7 inches wide (diagonal)
R.G.B. stripe
TFT active matrix
480 x 234 (WQVGA)
10/14/08 5:33:23 PM
10/14/08 5:33:23 PM
Publicité
