Publicité
Les langues disponibles
Les langues disponibles
Installation
Example of installation on the floor
mat or on the chassis
1. Place the amplifier where it is to be
installed. Insert the supplied tap-
ping screws (4 mm × 18 mm) into
the screw holes. Push on the screws
with a screwdriver so they make
marks where the installation holes
are to be located.
2. Drill 2.5 mm (1/8 in.) diameter holes
at the point marked, and install the
amplifier, either on the carpet or
directly to the chassis.
Drill a 2.5 mm (1/8 in.)
diameter hole
11
Tapping screw
(4 mm × 30 mm)
Floor
mat or
chassis
Publicité
