Replacement Parts; Operating Procedure - AIR SYSTEMS INTERNATIONAL POA-2 Manuel D'utilisation

Masquer les pouces Voir aussi pour POA-2:

Manuel d'utilisation (9 pages)

Manuel d'utilisation (8 pages)

Table des Matières

Les langues disponibles

The POA series of remote manifold boxes is designed to meet NIOSH requirements (adjustable regulator, pressure

gauge, safety relief valve, and respirator coupling(s) for a point-of-attachment when the work area is of consider-

able distance from the filtration source or main air supply. The POA series must be supplied with Grade-D air at

the required air pressure (psi) and volume (cfm).

Note: These units should be operated in the closed

position to prevent contamination and damage to

the internal components.

SPEciFicAtiOnS

Size

40.64 cm x 33.02 cm x 15.24 cm

Weight

Number of outlets depends on

Outlets

Maximum Air

Flow (cfm)

Maximum Inlet

Pressure

Maximum Outlet

Pressure

Relief Valve

Regulator

Adjustable, 0-125 psi (8.6 bar)

Note: All information in this manual applies to the wall mounted units as well.

Step 1)

Attach a 1/2" (13mm) incoming air line from the Grade-D compressed air source to the inlet fitting.

Step 2)

Attach desired respirators and lengths of hose to the quick connect outlet couplings.

Step 3)

Adjust the outlet pressure to the setting recommended by the respirator manufacturer. Turn the knob clockwise

to increase pressure, counterclockwise to decrease pressure.

• Make sure all personnel have egressed from the work area.

• Shut off air source to the Point-of-Attachment box.

• Remove air pressure from the Point-of-Attachment box by pulling out the relief valve ring.

• Disconnect airline hoses.

• Install dust caps, if applicable.

OvErviEw

16"L x 13"H x 6"D

10.5 lbs (4.8 kg)

model ordered

80 scfm@110 psi

2265 LPM@7.6 bar

150 psi (10.3 bar)

125 psi (8.6 bar)

OPErAting PrOcEDurE

ShutDOwn