Honeywell INSIGHT HPA5100 Serie Guide D'utilisation page 6

OPERATION
a
1. Ensure that the plastic wrap has been removed from the filters and the filters are replaced in the unit. Next,
plug the power cord into a working electrical outlet.
2. Tap Power Button
setting until another cleaning level is selected. Continue tapping
each tap, one of the cleaning level icons will illuminate on the InSight Display.
QUIET CLEAN
GENERAL CLEAN
POLLEN : optimizes pollen capturing performance during pollen season.
3. To shut off, tap the Power Button
TURBO MODE
When Turbo mode is selected, the Turbo icon
operates the air purifier at the highest cleaning level and maximizes its ability to help clean the air and
help reduce odors and VOCs quickly. Tapping the Turbo button again will return the air purifier to the
previous cleaning setting.
AUTOMATIC CLEANING MODE & AIR QUALITY INDICATOR
(only available in the HPA5200, HPA5250, HPA5300 and HPA5350 Series)
These select air purifier models are equipped with VOC Sensors that detect the level of VOCs in the room
and provide a visual display to indicate air quality. The Air Quality Indicator color display is located on the
InSight Display. The VOC Sensor is constantly monitoring the air and the Air Quality Indicator
light will illuminate either green, yellow, or red depending on the level of VOCs detected in the room:
Green – Good air quality. There is a low level of VOCs detected.
Yellow – Moderate air quality. There is a moderate level of VOCs detected.
Red – Poor air quality. There is an elevated level of VOCs detected.
VOCs are gases that are emitted from certain household cleaning, home improvement, and even common home
decor products.
When the Auto mode is activated, the air purifier will automatically operate at the appropriate cleaning level to
reduce the VOCs that are detected in the room. To select this mode, tap the Auto button
illuminate on the InSight Display to indicate the setting has been activated.
NOTE: Upon start up, the unit may take a few minutes to calibrate and measure the air quality. During this time,
the Air Quality Indicator will pulse between green, yellow, and red until the air quality is determined. When the
appropriate reading is determined, the indicator will then remain a solid color.
to turn on the air purifier. The air purifier will start automatically on the Quiet Clean
: quietest setting and optimized to capture small particles.
: recommended for dust and general, everyday air cleaning.
until the air purifier shuts off.
The energy efficiency of this ENERGY STAR
certified model is measured based on a ratio
between the model's CADR for Smoke and the
electrical energy it consumes, or CADR/Watt.
to choose a different cleaning level. With
will illuminate on the InSight Display. This setting
6
and the icon will