HEINE mPack LL Mode D'emploi page 6

HEINE mPack LL
®
All manuals and user guides at all-guides.com
Please read and follow these instructions for use and keep them for future reference.
General Conditions of Warranty
Instead of the statutory warranty time period of 2 years, HEINE will grant a guarantee of 5 years from the date
of the consignment of the goods ex works, concerning its equipment (excluding disposables, e.g. bulbs, single-
use articles, and rechargeable batteries). Date of consignment means that HEINE hands the goods over to the
transport carrier, freight forwarder or any other person designated by the Customer for the transport of the goods
without loading the collecting vehicle.
The guarantee covers irreproachable workmanship, on condition of the proper use of the equipment and the
observation of the operating instructions. During the warranty- and guarantee time period, errors and deficiencies
arising on the equipment will be rectified free of charge, in so far as such are evidenced by defective materials,
processing and/or constructional errors. Should buyer complain of a material deficiency during the warranty time
period, then the onus of proof is always to be on the orderer, that the product was defective already upon receipt
of the goods. The statutory warranty and the guarantee do not apply to loss or damage caused by wear and
tear, negligent use, the non-employment of original HEINE components and/or spares (in particular bulbs, as
these have been especially developed for HEINE instruments in accordance with the following criterions: colour
temperature, useful service life, safety, optical quality and performance. The statutory warranty and the guarantee
do not apply to interventions by persons not authorised by HEINE or when the operating instructions are not
observed by the customer.
Any modification of a HEINE product with parts or additional parts which do not conform to the original HEINE
specification will invalidate the warranty for the correct function of the product and further invalidate any warranty
claims which result from such a change or modification. Further claims, in particular claims for replacement of
loss or damage, which are experienced otherwise than directly on the HEINE product itself, are hereby excluded.
Intended Use
The HEINE mPack LL power source is designed solely for use with HEINE instruments. When wall-mounted, the
®
instrument support is designed for use with HEINE headbands and S-Frames only.
For U.S. only:
Federal law restricts this device to sale by or on the order of a Physician or Practitioner!
Warnings and Safety Information
CAUTION! Indicates potential hazardous situations. Ignoring the corresponding instructions may lead to
dangerous situations of mild to moderate extent. (Background color yellow; foreground color black).
NOTE! Indicates valuable advice in terms of installation, operation, maintenance or repair. Notes are
important, but not related to hazardous situations.
Product overview
3
2
6/40
4
med 1914 2014-08-08
Setting up and operation
The HEINE mPack LL can be charged with the HEINE
®
EN50 or directly with the HEINE Plug-in Transformer.
Please read the respective user manual.
Charge the mPack LL for two hours before using it for
the first time.
Connect the instrument to the connector (2) and select
the required brightness by means of the brightness
control (3). The HEINE
®
audible click after use.
With the mPack and EN50 (7), it is possible to use a
HEINE instrument under static or mobile conditions if
preferred. The mPack will be recharged automatically
when the attached HEINE instrument is switched off.
The indicator (4) lights up as soon as the mPack LL
is switched on with the controller (3). When the unit is
switched off, the indicator doesn't light up.
ENGLISH
mPack LL switches off with an
®