Samsung RR82PBBB Mode D'emploi page 7

REVERSING THE
REFRIGERATOR DOOR
Samsung recommends that reversing of
the door opening is only completed by
WARNING
Samsung approved Service providers.
This will be on a chargeable basis and at
the customers expense.
Any damage caused while attempting to
reverse the door opening is not covered under
the appliance manufactures warranty.
Any repairs requested due to this circumstance
will be completed on a chargeable basis at the
customers expense.
Required Tools (Not provided)
Phillips Head
Driver (+)
8 mm
Socket Wrench
(for hinge shaft)
(for bolts)
1. Remove 2 screws on the top of the refrigerator.
Screw
2. Remove the plastic cover and make sure to
disconnect the wire connected to it.
After removing the plastic cover, check the parts
for reversing the door.
Be careful not to damage the electrical
wires when removing the plastic cover.
CAUTION
DA99-01950G-09.indb Sec4:7 DA99-01950G-09.indb Sec4:7
10 mm Socket
Flat Head
Wrench
Driver (-)
(for bolts)
4 mm Hex
Spanner Wrench
(for bottom
hinge shaft)
3. Disconnect the wires and then remove 3 bolts.
Make sure your refrigerator is unplugged
before handling electrical wires.
WARNING
4. Remove the door from the lower hinge by carefully
lifting the door straight up.
Refrigerator door is heavy, be careful
not to injure yourself when removing the
CAUTION
refrigerator door.
5. Separate the front leg cover after removing
2 screws.
Screw
6. Unscrew 3 bolts tightening the hinge and also
unscrew 3 bolts on the bottom left side by the front
leg where removed hinge will be attached.
10mm
10mm
_7
setting up
13. 7. 2. 13. 7. 2. 11:04 11:04