Urmet alpha 1168/1G Guide Rapide D'utilisation page 10

TECHNICAL SPECIFICATIONS / KEY TO SYMBOLS
Power voltage: ................................................................................................................................ 36÷48 V
(Power supplied directly by door unit ref. 1060/48 via BUS wire).
Direct input voltage
DEVICE CONFIGURATION
To configure the device, see the technical system manual in the Technical Manuals / Communication /
Ipercom System section on the www.urmet.com website.
COMPLETE USER INSTRUCTION BOOKLET
For more information on how to use the device, download the calling module use complete manual in
Ipercom systems by scanning the following QR Code with the camera of your smartphone or tablet.
http://qrcode.urmet.com/default.aspx?prodUrmet=142071&lingua=en
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1) This device may not cause harmful interference.
2) This device must accept all interference received, including interference that may cause undesired
operation.
15.105 Information to the user statements:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
RF exposure warning statement
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must
be maintained between the antenna of this device and all nearby persons.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
10
See the installation manual of the device
DS1168-034A