Nakayama EH4510 Mode D'emploi page 7

EN
Sharpening the blade
• Allow the blades of the hedge trimmer to come to a stop in the position shown in figure 6. This will create space between the cutter teeth and the guard
teeth and allow for easy sharpening.
• Disconnect the power tool from the power supply.
• Clamp the blade in a vise and sharpen the sharp edges of each tooth with an 8 inch (20 cm) smooth round file, 1/4 inch (0.6 cm) or 7/32 inches (0.55 cm) in
diameter. Be sure to retain the original angle of the tooth when filing.
• Remove the hedge trimmer from the vise, reconnect it to a power source and restart the hedge trimmer.
CLEANING INSTRUCTIONS
Warning: Always switch the machine off, disconnect it from the power supply and let it cool down before performing inspection, maintenance
and cleaning work.
• Use a small brush to clean the outside of the unit. Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic.
• Wipe off any moisture with a soft cloth.
• Inspect the product before and after each use for worn and damaged parts. Do not operate it if you find worn and damaged parts.
Note: If the cutting blade is blocked by foreign objects during operation, switch the power tool off, wait until the cutting blade stops moving completely, remove
the foreign objects and then clean the cutting blade.
TRANSPORT
• Clean the product as described above.
• Always carry the power tool by its handle.
• Ensure that the machine is protected from any heavy impacts or strong vibrations which may occur during transportation in vehicles.
• Secure the machine to prevent it from slipping or falling over.
STORAGE
• Clean the product as described above.
• Store the machine and its accessories in a dark, dry, frost-free, well-ventilated place.
• Always store the product in a place that is inaccessible to children. The ideal storage temperature is between 10 °C and 30 °C.
• We recommend using the original package for storage or covering the product with a suitable cloth to protect it against dust.
TROUBLESHOOTING
Problem
The power tool does not start
The power tool does not reach
full power
Unsatisfactory performance
Excessive vibration or noise
The machine suddenly stops
working
ENVIRONMENTAL DISPOSAL
In order to avoid damages on transportation, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plastics components are marked according to their material, which makes it possible to remove
environmental friendly and differentiated because of available collection facilities.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.
7
Possible causes
Not connected to power supply
Power cord or plug is defective
Other electrical defect on the product
Startup instructions were not properly followed
Extension cord not suitable for operation with this product
Air vents are blocked
Cutting blades are worn
Bolts/nuts are loose
The machine was disconnected from the power supply
WWW.NIKOLAOUTOOLS.GR
Solution
Connect to power supply
Have the power tool checked by a specialist electrician
Have the power tool checked by a specialist electrician
Refer to section ''Switching on the power tool''
Use a proper extension cord
Clean the air vents
Sharpen the blades or replace them with new ones
Tighten the bolts/nuts
Reconnect the machine to a power source