Elipson Stream S300 Xi Manuel D'utilisation page 24

EN
VI. 2.4G & 5G DÉCLARATION / STATEMENTS
RF Exposure Information: To maintain compliance with FCC RF exposure
requirements, use the product that maintain a 20cm separation distance
between the user's body and the host. MPE (Maximum Permissible Exposure)
limit for RF exposure at prediction frequency and satisfy RF exposure
compliance.
Informations sur l'exposition aux RF : Pour rester conforme aux exigences de
la FCC en matière d'exposition aux RF, utilisez le produit en maintenant une
distance de séparation de 20 cm entre le corps de l'utilisateur et l'hôte. La
limite MPE (Exposition maximale admissible) pour l'exposition RF à la fréquence
de prédiction et satisfaire la conformité d'exposition RF.
FCC STATEMENT:
1. This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference,and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
24