Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE FEBREZE
• Insert scent cartridge completely into
the scent compartment. IT WILL ONLY
FIT IN THE AIR PURIFIER ONE WAY.
• Close the Scent Compartment door
• Set the scent control dial to adjust scent
intensity for personal preference
When the foil seal is removed or partially removed,
from the scent cartridge, the fragrance oils will be
exposed to the air and will start to evaporate. Once
the foil layer has been removed, you must use the
scent cartridge in the air purifier or dispose of it. It
cannot be re-sealed and saved for re-use later.
NOTE: The air purifier will also function without using a scent cartridge.
• Once the filter(s) and scent cartridge
are installed, plug the air purifier into a
working electrical outlet.
• Make sure you have selected the desired
scent intensity.
• Turn the Control Dial to the desired
cleaning level
III = High, II = Medium, I = Low.
A green LED will illuminate to indicate that
the unit is powered "ON".
The unit will start up at the High speed.
Portable air purifiers are more effective in
rooms where all doors and windows are
closed. In general, it is recommended that
you run your air purifier while you are at
home to clean the air.
6
All manuals and user guides at all-guides.com
SCENT CARTRIDGE (cont.)
™
OPERATION
Control Panel
Scent Cartridge
Scent Control
Compartment
Dial
Power Indicator
Light
ELECTRONIC FILTER AND SCENT CHECK REMINDERS
This Febreze™ Air Purifier has electronic filter and
scent check reminders. There is a FILTER RESET
button and a SCENT RESET button on the control
panel with a red LED light next to each. Based
on hours of use, the red LED will illuminate when
it is time to replace the filter(s) and/or the scent
cartridge. It is recommended that the air filters be
replaced every 4 months and the scent cartridge
will last up to one month. When the recommended
time period has elapsed the red light will come on
as a reminder to replace the filter(s) or the scent
cartridge. The red LED(s) will remain on until the Filter or Scent button is RESET. You
may unplug the air purifier without interrupting the filter or scent check.
You should periodically check the filter(s). Depending on operating conditions, the filter(s)
may need to be replaced more or less frequently. One scent cartridge will last up to 30
days, depending on desired scent intensity and operating speed. You may replace the
scent cartridge more or less frequently than the recommended 30 days.
To RESET the Electronic Filter or Scent Check
When the filter or scent check lights remain on, it is time to replace the filter(s) or scent
cartridge and RESET the filter or scent monitor. Old filter(s) or scent cartridge should be
removed and new ones installed.
Reset the Filter monitor.
• Install a new Febreze
• With the unit powered on, press the FILTER
RESET button next to the red LED and hold for
approximately 2 seconds until the light turns off.
Reset the Scent monitor.
• Remove old scent cartridge and
dispose of properly
• Install a new Febreze
• With the unit powered on, press the SCENT
RESET button next to the red LED and hold for
approximately 2 seconds until the light turns off.
Early Reset Option
Depending on your individual usage (environment and hours used), you may wish to
replace filter(s) or scent cartridge BEFORE the red indicator light turns on. If this is the
case, you will need to do an early RESET. To do this, press the Filter Reset or Scent
Reset button and hold for approximately 5 seconds to illuminate the red LED, then press
Cleaning
the Filter Reset or Scent Reset button again and hold for approximately 2 seconds until
Level
red LED light turns off. This will cause the usage cycle time to restart again for 4 months
Control Dial
for the filter(s) and 1 month for the scent cartridge.
Scent Cartridge
indicator light
Air Filter(s)
TM
U
Air Purifier Scent Cartridge
Scent Cartridge
TM
Reset Button
Filter change
indicator light
Filter Reset Button
7
Publicité
