akkuteam VAS 5903 Instructions De Service page 63

Current input test Important! before disconnecting the charging terminals from the battery, the displayed
finished - battery parameters must be entered on the battery test sheet in accordance with the Volkswa-
faulty gen Group testing instructions for starter batteries.
1.
2.
3 . If the terminals are disconnected from the battery in this mode, the machine reverts
After a pre-defined test time, the current input test ends and the results are shown
on the display:
Bsp.: Batterie defekt
If the battery is classed as faulty, the battery does not continue charging.
Press the Info button to retrieve the following parameters:
E.g.: charging current
E.g.: set battery capacity
E.g.: device serial number
E.g.: battery faulty
to the main menu
- the top half of the display shows the
results of the current input test (the
display shows DEFECT if the result
is negative)
- the bottom half of the display shows
the relevant validation code
E.g.: battery voltage
E.g.: battery's ability to
accept charge expressed
as in %
E.g.: firmware version
17