Publicité
Les langues disponibles
Les langues disponibles
Setting up the television
No.
Button
4
SLEEP
5
VOL + / -
6
MENU/ENTER
7
EXIT
8
INPUT
9
RECALL
10
MUTE
11
CH + / -
12
ZOOM
13
AUDIO
14
CCD
15
TUNER
Description
To set the television to turn off after
a preset amount of time, press the
SLEEP button. The clock counts up
ten minutes each time the button is
pressed in the order of 0, 10,
20...100, 110, 120 minutes. After the
sleep time is programmed, the
display disappears then reappears
momentarily every ten minutes to
remind you the sleep timer
function is operating. To confirm
the sleep time setting, press the
SLEEP button once and the
remaining time is momentarily
displayed. To cancel sleep time,
press the SLEEP button repeatedly
until the display turns to 0.
Press the + button to increase the
volume level. Press the - button to
decrease the volume level. Use
these buttons to select the desired
setting during the menu screen
operation.
Press to display the menu screen
function.
Press to enter or select operations
during operation of the menu
screen.
Press to remove the menu screen.
Press this button to display the
SOURCE SELECTION menu to
select the video input source.
Press this button to go back to the
previously viewed channel. Press
this button again to return to the
channel you were watching.
To turn off the sound, press this
button once. The television is
silenced and the symbol MUTE
appears on the screen. The muting
feature can be turned off by
pressing the MUTE button again or
one of the VOL + or - buttons.
button
Press the CH + (up)
to change
to a higher numbered channel set
the CH - (down)
into memory. Press
button to change to a lower
numbered channel set into
memory. Use to select the desired
setting during menu operation.
Press this button to change the
picture size.
Press this button to select the
desired sound.
Press this button to display the
CLOSED CAPTION menu.
Press this button to select the
analog/digital mode.
Setting up the television
Connecting your television to AC power
Use the AC polarized cord provided for operation on AC. Insert the AC
plug into a standard 120V 60 Hz polarized AC outlet.
Wider hole and
blade
Notes:
Never connect the AC plug to other than the specified voltage (120V 60 Hz).
Use the attached power cord only.
If the polarized AC cord does not fit into a non-polarized AC outlet, do not
file or cut the blade. It is your responsibility to have an electrician
replace the obsolete outlet.
If you cause a static discharge when touching the television and the
television fails to work, unplug the television from the AC outlet, then
plug it back in. The television should work normally.
Installing batteries in the remote control
Before using the remote control, you must install batteries. Use two AAA
size batteries. The batteries may last about one year depending on how
much the remote control is used. For best performance, we recommend
the batteries should be replaced on a yearly basis, or when the remote
operation becomes erratic. Do not mix old and new batteries or different
types.
To install batteries in the remote control:
1 Open the battery compartment cover.
2 Install two AAA batteries.
AC outlet
Polarized AC plug (one blade is wider
than the other.)
5
Publicité
