Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
18. ENSURE THE EXTENSION CORD YOU USE IS OF SUFFICIENT GAUGE
FOR ITS LENGTH.
RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS
Amps
25' long 50' long 75' long 100'
from Tool
Nameplate
0 - 5 amps
16 ga.
5.1 - 8 amps
16 ga.
8.1 - 12 amps
14 ga.
12.1 - 15 amps 12 ga.
15.1 - 20 amps 10 ga.
19. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across machines which are running.
20. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles dry,
clean and free from oil and grease.
21. DISCONNNECT THE TOOL FROM POWER when not in use, before
servicing,making any adjustments, or changing accessories. Changing
attachments or accessories can be dangerous if the tool accidentally starts.
22. AVOID UNINTENTIONAL STARTING. Don't carry tool with a finger on or near
the trigger. Be sure the On/Off switch is in the Off position when plugging the
tool into the power supply.
23. STAY ALERT. Watch what you are doing and use common sense. Don't
operate any tool when you are tired.
24. STORE IDLE EQUIPMENT. Store equipment in a dry area to inhibit rust.
Equipment also should be in a high location or locked up to keep out of reach
of children.
25. SECURE WORK. Use clamps or a vise to hold the work if possible. It's safer
than using your hands and it frees both hands to operate the tool.
26. REMOVE ADJUSTING KEYS AND WRENCHES. Make it a habit to check that
keys and adjusting wrenches are removed from any rotating tool before using.
27. MODIFYING A POWER TOOL in any way or using any attachment other than
those recommended in this manual could result in damage to the tool and
injury to the operator.
28. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for mis-alignment or binding of
moving parts, breakage of parts and mountings and for other conditions
that may affect tool operation. Check bits to make sure they are sharp and
not chipped. Inspect screws and tighten any that are loose. Any part that is
damaged should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in the instruction manual. Have
defective switches replaced by an authorized service center. Don't use the tool
if switch does not turn on and off properly.
29. REPLACEMENT PARTS. When servicing, use only identical replacement
parts.
long
16 ga.
16 ga.
14 ga.
16 ga.
14 ga.
12 ga.
14 ga.
12 ga.
10 ga.
12 ga.
10 ga.
10 ga.
10 ga.
10 ga.
Do Not
Use
150'
200'
long
long
12 ga.
12 ga.
10 ga.
Do Not
Use
Do Not
Do Not
Use
Use
Do Not
Do Not
Use
Use
Do Not
Do Not
Use
Use
3
Publicité
