Kärcher BLV 36-240 Battery Manuel D'instructions Original page 27

Removing blockage
Note
Do not try to remove the fan or mulching blades. If re-
moval of the mulching blades or fan is required, contact
an authorised Customer Service centre.
WARNING
Movement of the fan wheels and mulching blades
Incision injuries
Wear protective gloves.
Keep your fingers away from the fan and mulching
blades.
1. Switch off the device.
2. Remove the battery pack, see Chapter Removing
the battery pack.
3. Remove the collecting bag, see chapter Remove
the collecting bag.
4. Remove the suction pipe.
Illustration T
a Open the latch for the protective grid.
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Fault
The device does not start
up
The device stops during
operation
Warranty
The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Technical data
Device performance data
Nominal voltage
Average air speed of cordless
blower
Maximum theoretical air speed of
cordless blower
Average air speed of cordless
suction device
Maximum theoretical air speed of
cordless suction device
Mulch ratio
26
Troubleshooting guide
Cause
Battery pack is not inserted correctly.
Battery pack is empty
Battery pack is defective.
Safety button did not trip during assem-
bly.
The battery has overheated
Motor has overheated
V 36
km/h 225 +/-
10 %
km/h 275 +/-
10 %
km/h 172 +/-
10%
km/h 208 +/-
10 %
10:1
Автотовары «130»
b Unlock the suction pipe with the slider.
c Pull out the motor casing locking pin as far as
possible.
WARNING
Movement of the fan wheels and mulching blades
Incision injuries
Wear protective gloves.
Keep your fingers away from the fan and mulching
blades.
d Take the suction pipe off the motor casing.
5. Remove the blower pipe.
Illustration U
a Press the blower pipe unlocking button.
b Take the blower pipe off the motor casing.
6. If necessary, remove any blockage from the pipes.
7. If necessary, remove any blockage in the adapter.
8. If necessary, remove any blockage from the con-
necting piece.
9. Clean the openings of the motor casing.
As the battery pack ages, even if it is looked after, its ca-
pacity reduces such that the full run time will no longer
be reached when fully charged. This does not indicate a
defect.
Rectification
 Push the battery pack into the mounting
until it latches into place.
 Charge the battery pack.
 Replace the battery pack.
1. Unscrew the protective grid fixing screw
once again.
2. Tighten the protective grid fixing screw until
a clicking sound is heard.
The safety button has tripped.
 Stop working and allow the battery to cool
down to normal battery temperature.
 Stop working and allow the motor to cool
down.
Collecting bag volume
Dimensions and weights
Weight (without battery pack)
Length x width x height
Determined values in acc. with EN 50636-2-100
Sound level L Cordless blower dB(A)
pA
Sound level L Cordless blower/
pA
vacuum
Uncertainty K
pA
Sound power level L
tainty
WA
Total vibration value for cordless
blower
Total vibration value for cordless
blower/vacuum
Uncertainty K
Subject to technical modifications.
English
l
kg
mm
dB(A)
dB(A)
+ K uncer- dB(A)
WA
2
m/s
2
m/s
2
m/s
45
4,7
1290 x
230 x
449
88,6
88,9
3
104
3,2
4,1
1,5