Publicité
Les langues disponibles
Les langues disponibles
General Information
2. Remove the knockout in the back of the connection box (if
used), feed the wires through the back of the box and secure
the conduit with the lock nut.
Seal the hole with silicone caulk. Don't forget to caulk the hole
inside the house as well.
3. Mount the connection box (if used) so that it completely covers the
hole in the wall. Caulk around the sides and top of the box to ensure
a good seal.
Connect all wires to the lugs in the connection box (black to black,
red to red and white to white). Attach the green ground wire to
the ground screw and connect the two small plugs to their mating
receptacle ends.
4. Replace the protective cover plate and retaining screw, and
lock the connection box.
8
5. For 10-20 kW models, locate the metal hasp that is packaged
in the owner's manual bag. Insert the hasp in the slot located
on the left side of the external circuit breaker box. Be sure that
the clip of the hasp is facing toward the front of the generator.
If desired, lock the external box.
GENERATOR ACTIVATION
When battery power is applied to the generator during the
installation process, the controller will light up. However, the
generator still needs to be activated before it will automatically run
in the event of a power outage.
Activating the generator is a simple one time process that is
guided by the controller screen prompts. Once the product is
activated, the controller screen will not prompt you again, even if
you disconnect the generator battery.
After obtaining your activation code, please complete the following
steps at the generator's control panel in the Activation Chart
(shown on the following page).
GENERATOR CONNECTIONS – TRANSFER
SWITCH
1. If the Load Center transfer switch was purchased separately
from the generator it will need to be connected to the
generator. To complete the wiring, run power leads and
control wires from the transfer switch to the generator.
2. Remove the two screws securing the connection area cover,
and remove the cover.
4. Feed the wires through the back of the generator and secure
the conduit with the lock nut.
5. Run the power leads through the strain relief provided.
6. The circuit breaker is attached to the exterior access panel.
Publicité
