Uline H-6839 Instructions D'assemblage page 2

ASSEMBLE SHELVING UNIT
1. Start with the lowest shelf. Snap the interlocking
pieces of a shelf support (wide end down) around
the post at the lowest groove. (See Figure 1)
NOTE: There are two ridges on the inside of
each shelf support. The bottom shelf support
ridge should be aligned with the lowest groove
on the post.
Figure 1
2. Slide the shelf support up or down until it snaps into
the groove. Add shelf supports to the same place
on the remaining posts.
3. Slide posts through underside of shelf until shelf
slides firmly over shelf supports. (See Figure 2)
Figure 2
4. Stand unit upright. Gently tap shelf down to secure.
(See Figure 3)
Figure 3
5. Determine the height of the next shelf, snap on shelf
supports, then add and secure shelf. Repeat to add
the remaining shelves.
NOTE: Top shelf must be placed at top of posts.
PAGE 2 OF 9
ASSEMBLY
ATTACH LEFT SIDE AND BACK PANEL
1. Remove plastic top caps from all four posts.
(See Figure 4)
2. Install post inserts (located in post boxes) into top of
posts. Make sure post inserts are set all the way into
the top of post. Use a rubber mallet to secure the
inserts if needed. (See Figure 5)
Figure 4
3. Stand panels upright. Tilt the shelving unit so two
side posts are in the air. Lower shelving unit into
post slots located on the bottom corners of panels.
Secure top of panels to top of posts by screwing bolt
(located in post boxes) into post inserts.
(See Figure 6)
Figure 6
Figure 5
0421 IH-6839