Conceptsolutions PSS10 Guide D'utilisation page 4

SYMPTOM: The unit does not operate
1. Verify that the unit is plugged into the wall receptacle and power is switch on.
2. Verify that the unit is in the AUTO, FORWARD, or REVERSE position.
3. Verify that the unit is properly placed on the basket. (For safety reasons, the shredder will not operate
unless the shredder is properly placed).
SYMPTOM: The unit stops shredding
This shredder cannot be used for constant shredding for a long period of time. To protect the shredder
from damage, the overload protector will stop the shredder. The normal duty cycle for continuous
shredding at maximum capacity is 3 minutes ON and 17 minutes OFF.
SYMPTOM: Paper Jams
The following measure should be taken to remove paper jams from the paper entrance of the shredder:
1. Slide the switch to the REVERSE position to clear the jam.
2. Return the shredder into AUTO or ON position.
Other problems?
Call us on our toll-free support line at 1-877-259-7989 or email us help@conceptsolutions.biz
Attention
The shredder is not
intended for use by
children.
Avoid touching the
document feed opening
with hands.
Avoid clothing touching
the document feed
opening.
CONCEPT SOLUTIONS and the word mark are trademarks of Product Specialties Inc.
All manuals and user guides at all-guides.com
TROUBLEShOOTING
SPEcIFIcATIONS
Entry Width 8.75 in.
Shred Size 1/4"
Sheet capacity 10 sheets
Shredding speed 10 seconds for 10 sheets
Power 120v
222 mm
6.35mm
60hz
Avoid hair touching the
document feed opening.
Keep aerosol products
away.
Remove paper clips and
staples before shredding.
Do not exceed the 10
sheet-at-a-time capacity.