Conceptsolutions PSS10 Guide D'utilisation page 3

1. Position shredder over basket and extend adjustable arm so that the shredder firmly rests on basket
edges.
2. With shredder positioned on the basket, plug into outlet. Do not alter the plug.
3. Plug into outlet with the appropriate power requirements as stated on the bottom of the shredder. When
the basket is not in use, place it properly onto a rigid support and avoid any blockage of the strip outlet.
OPERATION (AUTOMATIc)
Prepare paper to be shredded. Remove staples and paper clips and make sure to feed no more than the
recommended sheet capacity at one time.
1. Press the ON/OFF switch on back of unit to the "ON" position.
2. Slide the main switch to the AUTO position to activate the standby mode.
3. The shredder automatically STARTS when paper is placed in the feed opening and STOPS when
finished shredding.
4. Press the ON/OFF switch on back of unit to the "OFF" position after use.
IMPORTANT NOTE: If paper is wider than the paper entrance and you fold it to fit, the paper thickness
increases and the recommended capacity may be exceeded.
OPERATION (MANUAL)
Prepare paper to be shredded. Remove staples and paper clips and make sure to feed no more than the
recommended sheet capacity at one time.
1. Press the ON/OFF switch on back of unit to the "ON" position.
2. Slide the main switch to the ON position to activate the shredder.
3. Place the paper into the opening of the shredder.
IMPORTANT NOTE: If paper is wider than the throat and you fold it to fit, the paper thickness increases
and the recommended capacity may be exceeded.
4. Return the main switch to the "AUTO" position when finished shredding.
All manuals and user guides at all-guides.com
INSTALLATION OF UNIT
hOW TO ShRED PAPER