Publicité
Les langues disponibles
Les langues disponibles
Set the NET2 Port's
Network Configuration Method
The NET2 port is set to inactive by default. To activate:
1
Click System > IP.
2
Click Management LAN Interface to make it the front-most tab.
3
Click the Deactivate this network interface checkbox to de-select this option and
activate NET2.
4
For Configuration Method, click either the DHCP or Static radio button.
5
If Static, enter an IP Address and Subnet Mask for the NET2 interface.
For out-of-band (OOB), set these for your management network.
For IP passthrough, set these to match an unused private IP range.
Note: The console server's firewall determines which protocols and services can access ports and
devices. HTTPS and SSH are enabled to the console server by default. To change access settings
for the console server and connected serial ports, click System > Services. Then click the Service
Access tab and adjust, as required.
Connect the Cellular Modem
Before proceeding, make sure at least one SIM card has been installed. For more
information, see Hardware Assembly section.
1
Click System > Dial.
2
Click the Internal Cellular Modem tab.
3
Check the Allow outgoing modem communication radio button.
4
Enter your carrier's Access Point Name (APN) in the APN field.
5
If you use DNS servers other than your carrier's servers, check the Override returned
DNS servers checkbox and enter your DNS addresses in the DNS server 1 and
DNS server 2 fields.
Note: Your carrier may provide other connection details. In general, only the APN is needed and
other fields can be left blank. If a pin code was provided, use it to unlock the SIM card.
6
Click Apply Modem Dial Settings. A data connection will be established with your
carrier.
5
Publicité
