Ingersoll Rand 88H-EU Serie Mode D'emploi page 3

WARNING: Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury.
Correct combinations are specified below:
Guard Part Number
88H60–961A
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
International – No. FRL30–C6–A29
Where lubricators cannot be permanently mounted, we
recommend using an Ingersoll–Rand No. 8LUB12
Lubricator.
Before starting the tool, unless an air line lubricator is
used, detach the air hose and inject about 1.5 cc of
Ingersoll–Rand No. 50 Oil into the air inlet. Remove the
Oil Chamber Plug and fill the chamber.
After each 8 hours of operation, or as experience
indicates, remove the Oil Chamber Plug and fill the
chamber.
Model Type of
Handle
88HL90L10–EU lever
Model Type of
Handle
88HL60H106–EU lever
G Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance with ISO8662–1 with artificial unbalanced load at 50% of rated speed for ungoverned tools and at
80% rated free speed for governed tools
GRINDER SPECIFIC WARNINGS
Wheel Type Wheel Diameter
1
PLACING TOOL IN SERVICE
Ingersoll–Rand No. 28
SPECIFICATIONS
Free Wheel
Speed
rpm
9,000 Cone
Free Wheel
Speed
rpm in
6,000 6
Maximum Wheel
in. (mm) Thickness
in. (mm)
6(152)
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Spindle
5/8" – 11
Spindle and
Guard
mm
152 5/8"–11, 6"
3
Maximum Speed
1(25.4)
FILTER
COMPRESSOR
(Dwg. TPD905–1)
GSound Level
dB (A)
Pressure Power
– – – – – –
GSound Level
dB (A)
Pressure Power
79.5 – – –
rpm
6,000
♦Vibrations
Level
2
m/s
– – –
♦Vibrations
Level
2
m/s
3.1