Lorell LLR60738 Instructions D'assemblage

Assembly Instructions
Cross Beam Base
1 Pcs 4 Pcs
Allen Key Allen Key Screw
(70*30-5mm) (70*70-6mm) (M8*35mm)
1 Pcs 1 Pcs 6 Pcs
STEP 1
Allen Key
(70*30-5mm)
1 Pcs
STEP 2
Screw
Allen Key
(M8*30mm) (70*70-6mm)
4 Pcs 1 Pcs
IMPORTANT NOTE:
· ·
Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
· ·
Check to be sure that you have all parts and hardware.
· ·
Remove all wrapping materials,including staples and packing straps before you start to assemble.
· ·
Don't tighten all screws/bolts until all the pieces are completely assembled.
· · Keep all hardware parts out children's reach.
· ·
It is recommended for 2 people to complete this assembled.
Leg Top Support Leg Cover
2 Pcs 2 Pcs 2 Pcs
Washer Screw Screw
(Ø8mm) (M8*30mm) (ST4*20mm) (ST4*14mm)
6 Pcs 4 Pcs 12 Pcs
Tighten Screws
STEP 3
(M8*35mm)
Leg Ring Cable Guide
2 Pcs 4 Pcs
Screw
8 Pcs
Screw Washer
(Ø8mm)
6 Pcs 6 Pcs
Training Table Base
LLR60738/60739
Loosen Screws
Insert D into A
Pull up the handle
to release the
lock between
bracket and legs.
Two people are required to
assemble and move this model.