Braun Wet&dry 9 Serie Mode D'emploi page 14

Shaving 1. Shaving system is
performance
dropped 2. Foil and cutter are worn.
significantly.
Shaver turns Foil and cutter are worn
off with fully which requires more power
charged than the motor can deliver.
battery. The appliance turns off.
Shaver head is 1. Drain of the Clean&Charge
damp.
2. Cleaning cartridge has
CLEAN&CHARGE STATION
Cleaning does 1. Shaver is not placed
not start when
pressing the
start button. 2. Cleaning cartridge does
3. Appliance is in stand-by
Increased Drain of the Clean&Charge
consumption of Station is clogged.
cleaning fluid.
14
All manuals and user guides at all-guides.com
clogged.
Station is clogged.
been used for quite a
while.
properly in the
Clean&Charge Station.
not contain enough
cleaning fluid (level
indicator blinks red).
mode.
1. Soak the Foil & Cutter cassette in
hot water with a drop of dish liquid.
Afterwards rinse it properly and tap
it out. Once dry apply a drop of light
machine oil on the foil.
2. Replace Foil & Cutter cassette.
– Replace Foil & Cutter cassette.
– Regularly oil the shaving system,
especially when cleaning with water
only.
1. Clean the drain with a wooden
toothpick.
2. The alcohol proportion has
decreased while the oil proportion
has increased. Remove residue
with a cloth.
1. Insert shaver into the Clean&Charge
Station (contacts of the shaver
need to align with contacts in the
station).
2. Insert new cleaning cartridge.
3. Press start button again.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.