Braun Wet&dry 9 Serie Mode D'emploi page 11

16 Start button
17 Cleaning cartridge (not with all models)
Installing the Clean&Charge Station (see fig. D)
• Press the lift button (13) at the rear side of the Clean&Charge Station to lift up the
housing.
• Hold the cleaning cartridge (17) down on a flat, stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge from the rear side into the base of the station until it snaps into place.
• Slowly close the housing by pushing it down until it locks.
• Connect the station to an electrical outlet by snapping the special cord set (10) into
the power socket (12).
Charging the shaver in the Clean&Charge Station (see fig. D)
Insert the shaver head with the front showing and released head lock into the cleaning
station. Important: The shaver needs to be dry and free from any foam or soap
residue!
The contacts (7) on the back of the shaver need to align with the contacts (14) in the
station. Push the shaver in the correct position. A beep sound confirms that the shaver
sits properly in the station. Charging will start automatically.
Cleaning the shaver (see fig. D)
When the cleaning indicator
Clean&Charge Station, as described above and press the start button (16).
The hygiene status will be analyzed and is shown by the cleaning program indicators
(15c) in the Clean&Charge Station display.
If status light (15b) does not shine (Clean&Charge Station switches to stand-by after
ca. 10 minutes), press start button twice. Otherwise cleaning will not start. For best
shaving results, we recommend cleaning after each shave.
The cleaning process consists of several cycles, in which cleaning fluid is flushed
through the shaver head. Depending on the program selected, the cleaning time takes
up to 3 minutes, followed by an active drying phase of about 40 minutes, during which a
fan is running.
Afterwards charging will resume, which is indicated in the shaver display. When the
shaver is fully charged the display turns off.
Cleaning programs
short economical cleaning
normal level of cleaning
high intensive cleaning
Removing the shaver from the Clean&Charge Station (see fig. E)
Hold the Clean&Charge Station with one hand and tilt the shaver slightly to the front to
release it.
All manuals and user guides at all-guides.com
lights up in the shaver display, insert the shaver into the
11