LEGRAND WattStopper HB300-B L1 Instructions D'installation

No: 24160 – 2/17 rev. 1
Catalog Numbers • Les Numéros de Catalogue • Números de Catálogo: HB300-B, HB300C-B
Country of Origin: Made in China • Pays d'origine: Fabriqué en Chine • País de origen: Hecho en China
HB300-B L1
HB300-B L7
The HB300-B and HB300C-B occupancy sensors are designed for automatic lighting control in warehouse and high bay applications.
They contain a passive infrared sensor (PIR) and are made up of two parts, a Power Module (HB300-B) and a Lens (HBLx). The
coverage area is determined by the lens module. The lenses are interchangeable with any HB3xx series sensor. See the HBLx Lens
Coverage Guide for more information.
The sensor model uses a set of DIP switches to set the time delay and PIR sensitivity. The HB300-B sensors operate at 24VDC and
requires a Wattstopper power pack.
The HB300-B basic model provides a single output to the power pack, which is controlled only by occupancy.
The HB300C-B is for colder ambient temperature applications: -40° to 131°F (-40° to 55°C)
Coverage patterns, density and range, are determined by the type of Lens attached to the HB300-B.
For a complete description of each lens coverage pattern, see the HBLx Lens Coverage Guide.
1. Determine the mounting location appropriate to the features of the power module and the coverage area. Careful consideration must be
given to sensor placement. Avoid placing the sensor where shelving or other obstructions may block the sensor's line of sight.
2. Make sure that you have the appropriate accessories for the sensor mounting configuration. (See Mounting Options.)
3. Assemble any necessary mounting accessories and attach them to the power module, making sure that the flying leads from the
power module are accessible.
4. Connect the line voltage and load wires to the power pack leads as shown in the Wiring Diagram for the unit's application.
• Do not allow bare wire to show.
• Make sure all connections are secure.
5. Attach the Lens to the HB300-B as shown in Fig. 3.
6. Restore power from the circuit breaker.
Wattstopper
High Bay • Low Voltage • Passive Infrared Occupancy Sensor Power Module
Grande hauteur • Basse tension • Infrarouge passif Module d'alimentation
du détecteur de présence
Módulo de alimentación •de bajo voltaje • para el sensor de ocupación
infrarrojo pasivo para áreas de almacenamiento elevadas
Installation Instructions • Instructions d'Installation • Instrucciones de Instalación
HB300-B L2/
HB300-B L3
DESCRIPTION AND OPERATION
COVERAGE
INSTALLATION
®
SPECIFICATIONS
Voltage ................................................................... 24VDC
Power Consumption ................................................... 7mA
Power Supply
BZ power pack ................................up to 15 sensors