Publicité
Les langues disponibles
Les langues disponibles
With the mounting holes (4) you can easily and firmly mount the
battery charge on a desired place.
Use suitable screws and do not tighten the screws too much in
order not to damage the suspension eyes.
Attention!
First connect the quick clamps (5 and 6) with the battery poles
and than plug the power plug into the socket.
After charging, first unplug from power mains before removing
the quick clamps.
Built-in Safety Features
With the built-in safety features the battery charger is secured
against misuse and errors. There is no risk of over charging the
battery and the charger will not damage vehicle electronics.
Protection
against
malfunction
resp. misuse
Overheating
Protection
All manuals and user guides at all-guides.com
To avoid damaging the charger and the battery,
the charger will turn off his own electronic
system and will immediately reset the system to
STANDBY mode in the case of:
- Short Circuit
- Wrong Connection
- Open Circuit
- Reversed Polarity Connection
- Battery Voltage below 7.5 V ± 0.5 V
The charger will remain in STANDBY mode and
LED will light up to indicate reverse polarity or
fault.
The charger is protected by a NTC controller
(negative temperature coefficient controller).
If the charger becomes too hot or due to high
ambient temperature while charging, the power
output will be automatically decreased.
Using
26
Publicité
