Facom E.6000-C1000 Notice Originale page 8

Sensor Selection
FACOM provide a full range of sensors to cover a wide range of torque values. An appropriate sensor should be selected
to ensure the maximum sensor range exceeds the maximum value of the wrench being tested. For greatest accuracy
choose the sensor closest to the desired test value.
For Surface Mounting
Can be mounted vertically or horizontally.
Hole centres – (refer to drawing).
Note – ensure surface is secure enough to support the applied torque.
For CD.12A Mounting
Sensor should be mounted vertically.
Ensure fastening screws are tightened to the relevant torque (see speci cations).
3. SPECIFICATIONS
REF Torque
Range
E.6000-C1000 10-1000 N.m
E.6000-C400 20-400 Nm
E.6000-C50 5-50 N.m
E.6000-C30 1-30 N.m
E.6000-C5 0,5-5 N.m
E.6000-C12 0,04-1 N.m
REF
E.6000-C1000
E.6000-C400
E.6000-C50
E.6000-C30
8
NU-EC6000_0717 ttes langues sur site.indd 8
CW
External Drive
Dimensions Square
(LxWxH)
(mm)
160x105x108 3/4 "
145x92x92 1/2 "
105x65x80 3/8 "
105x65x80 1/4 "
105x65x80 1/4 "
105x65x80 1/4 "
Range
Low High
10 1000
20 400
5 50
1 30
CCW
Hole Centres Screws
for mounting (Class 12.9)
(") (mm)
114
100
70
70
70
70
Accuracy
1% 0.50%
10-99 100-1000
20-39 40-400
N/A 5-50
1-2 3-30
Mounting
Hole Centres Tightening
M14 Ø15
M12 Ø13
M8 Ø9
M8 Ø9
M8 Ø9
M8 Ø9
Screw
Torque
120 N.m
100 N.m
40 N.m
40 N.m
40 N.m
40 N.m
07/08/2017 14:35:53