Publicité
Les langues disponibles
Les langues disponibles
SHOWER TOILET 540 / 540
INSTRUCTIONS FOR REMOTE CONTROL INSTALLATION
Method 1:
1. Install the remote controller xing panel with a magnet on the remote control xed seat and lock tightly.
Note: Pay attention to the polarity when installing the magnet. Place the larger side of the magnet hole outside
the xed panel and enclose the small hole surace inside the xed panel; as shown in the below gure 1.
2. Put the double sided tape on the remote control xed seat.
3. Clean dust, grease, water droplets on the walls and wipe them clean.
4. Press the remote control xed seat with double sided tape on it, Press it evenly or 3 to 5 min Utes.
Note: The method is applicable to glazed tiles, glass and smooth wall.
gure 1
Method 2:
1. Drill the holes with a diameter o 6mm in a vertical axis with a
distance between 48mm to 50mm and 22mm depth into the wall.
Note: To ensure good accessibility, the bracket should be placed at an adequate height.
2: Insert the dowels and screw the base plate to the wall.
Mount the base plate over the magnet on the remote control and lock it rmly.
Note: Pay attention to the polarity when attaching the magnet.
Drilling distance zone
Put the remote controller on the xed base ater installing the battery, and the remote controller can automatically
absorb on the xed base.
Note:
Please place the remote on the xed place i not use.
(To avoid the remote falling down)
It may cause damage if the remote controller falls down.
Please do not spill water on the remote control or drop
into the water, or it may cause damage.
Pro -
Magnet
560 / 560
Pro
double
sided
tape
Magnet
11
Publicité
